It is recommended the project installer perform the items contained on this Checklist as fixtures and PoE Components are installed.

**Node / Light Fixture ** Check
Light fixtures in final locations per PoE lighting layout
Ensure all Category Cables that connect Nodes, Fixture, or fixtures after the Splitter to a PoE PSE Switch are labeled at both ends and indicated on an as-built map
Check Node flash Pattern 1 single flash
If installed, test battery back-up by pushing test buttons or turning off the circuit connected to the PoE Switch
Create as-built map of Network employing the Pull Schedule made prior to installation

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment