The inspeXtor™ Light Management System typically resides on a dedicated Linux 1U Sever that looks like this:

While the management of all light fixtures are controlled by the inspeXtor™ system, each light is physically connected to inspeXtor™ System via category cable, which is plugged into a RJ45 port on the fixture. If one light fixture is inoperable or flashing, please check the inspeXtor™ connections relevant to this fixture including:

Fixture Port:

Spitter Ports

PSE Port

Finally, in cases where an inspeXtor™ Lighting Fixture has it’s own PSE Port, please check the status of that PSE port on inspeXtor™.

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment