inspeXtor™ Node/Driver

The inspeXtor™ Node and Driver are located on one board and situated in one housing. The Node/Driver can be integrated into a PoE Compatible Light Fixture or deployed externally. There is one power input (which connected via category cable to a PSE Port), one Peripheral Output Port and Two (2) Power Output Ports on each Node/Driver.

Specifications

Fixture Agnostic up to 71 Watts
RJ45 Connection Type Internal or Optional Remote Mount
Engineered to Respond to the inspeXtor™‘s Peripheral Communication Network
Automatic Network Discovery
Ultra High Electrical Conversion Efficiency of 98%
Supports Optional inspeXtor™‘s UL924 Listed Battery Backup
Features a Dimming Range of 1% to 100%
Dimensions: 7” x 2.75” x 1.5”Operating Temperature 32°F to 104°

Supply Voltage – 24-56 Vdc
Max Output Current – 1.3 Amps
Response Time – 0.1 Sec
Data Rate – 4 Kbit/Sec
Off-Mode Power Consumption – 0.5 Watts
Dimming Transition Time – 0.1 to 25 Seconds
Maximum Wire Length to Node – 20 Feet
60 Vdc Surge Protection & Short Circuit Protection

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment