Battery backup Check
Node PoE Port is unplugged
Connect Port 1 on Node to input of the battery backup
Connect Output of Battery backup into input of Splitter which output is connected to the fixtures
Connect Battery enable harness
Ensure that Control Port Green LED is flashing Once per second
Ensure that input Port Green LED is flashing once per second.

Battery backup input port Flash pattern
One flash per second = Monitor mode. Battery is charging.
Two flash per second = Drive mode battery is ON.
Three flash per second = Low Battery Mode

In order to test the fixture, push the Battery Test button and the fixture(s) will remain illuminated typically at a lower lumen output, which means the fixture will appear dimmer than normal.

Feedback

Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment